eMotion Family Virtual Bench

Motor Drivers/Sensors
1

Hi,

I hope to design using MP6570.
I have reviewed the datasheet and tried to download"eMotion Family Virtual Bench", but I can’t find it.
MP6570 supports 3 communication methods(default is I2C). Which communication tools are supported by MPS?

Yong.

2

Hello Marci,

Please refer to this post here: eMotion Virtual Bench Software not available online - Motor Drivers/Sensors - Monolithic Power Systems’ Technical Forum. You can find the link for the software there.

Thank you,
Vinh Tran

3

Thanks Vinh Tran.

I was flow link your given.
But I can not find it. I just find MotionLAB.
Is it correct?

Yong.

4

Hello Marici,

Yes, MotionLAB is the correct software.

Thank you,
Vinh Tran

5

Hi Vinh Tran.

I was download and run it.
If I receive the communication kit from the distributor, I can try to do more.
I received MP6570 from the distributor and I am designing my board.
In this case, can I tune and test my board in MotionLAB?
If possible, please give me the guidelines.
If not, how can I tune and test my board?

Communication kits have been requested through distributor.

Thanks!

Yong

6

Hello Marici,

Yes, the MotionLab software should be able to tune your board. Please reach out to MPS NOW Remote Support to get the EVKT-MP6570 guide.

Regards,
Vinh Tran

1 Like
7

Thanks Vinh Tran.

I will check it.
If I have any more question, I will come back again.

Thanks!

Yong.